| Standards: | IEC60061-3 | Warranty: | 12 Months |
|---|---|---|---|
| Material: | Mold Steel | 7006-73-1: | Gauge For Bi-pin Cap G5.3 On Finished Lamps |
| Purpose: | To Check The Cap G5.3 Shown On Sheet 7004-73 | Type: | Lamp Cap Gauge |
| High Light: | IEC60061-3 Lamp Cap Gauge , CSA Lamp Cap Gauge , SGS Bi-pin cap gauge |
Gauge for bi-pin cap G5.3 on finished lamps 7006-73-1
7006-73-1
Gauge for bi-pin cap G5.3 on finished lamps 7006-73-1
Purpose:
To check the cap G5.3 shown on sheet 7004-73 in the following respects:
-the combined displacement and diameter of the pins (dimensions D and E) with respect to the
maximum horizontal section (dimensions A max. and B max.) of the cap;
-the minimum height of the shell (dimension C min.);
-the diameter of the individual pins (dimension E);
-the length of the pins (dimension F).
Testing:
-It shall be possible to insert the cap into the gauge with the pins entering at surface Z until
the supporting feet of the shell are in contact with surface Z.
In this position, the ends of the pins shall be co-planar with or project beyond surface X but shall
not project beyond surface W.
In additon, the top edge of the shell shall be co-planar with or project beyond surface Y.
-In carrying out this check the force used shall not exceed 5N.
-It shall be possible to insert the individual pins of the cap into the hole e2 until the level of the
supporting feet is coincident with surface W.
-It shall not be possible to insert the individual pins into hole e1.
Conforms To:
IEC60061-3 G5.3 7006-73-1
Application:
Guangzhou Shice Equipment offers a wide range of gauge to meet the most common standards
including those from IEC, EN, UL, GB,DIN,VDE and others. Such standards require the
checking of size & definition etc. these gauges are constructed from senior stainless steel
and appropriate steel with a hardness of at least 60 HRC and a roughness according to
standard require. Each gauge is supplied with a certificate of calibration.
